Yaskawa Servo Motors 750W SGM7J-08A7C6S
Voltage | 200 V | |||||||
Model SGM7J- | A5A | 01A | C2A | 02A | 04A | 06A | 08A | |
Time Rating | Continuous | |||||||
Thermal Class | UL: B, CE: B | |||||||
Insulation Resistance | 500 VDC, 10 MΩ min. | |||||||
Withstand Voltage | 1,500 VAC for 1 minute | |||||||
Excitation | Permanent magnet | |||||||
Mounting | Flange-mounted | |||||||
Drive Method | Direct drive | |||||||
Rotation Direction | Counterclockwise (CCW) for forward reference when viewed from the load side | |||||||
Vibration Class*1 | V15 | |||||||
Environmen- tal Condi- tions |
Surrounding Air Temperature | 0°C to 40°C (With derating, usage is possible between 40°C and 60°C.)*4 | ||||||
Surrounding Air Humidity | 20% to 80% relative humidity (with no condensation) | |||||||
Installation Site | • Must be indoors and free of corrosive and explosive gases.• Must be well-ventilated and free of dust and moisture.• Must facilitate inspection and cleaning.• Must have an altitude of 1,000 m or less. (With derating, usage is possible between 1,000 m and 2,000 m.)*5• Must be free of strong magnetic fields. | |||||||
Storage Environment | Store the Servomotor in the following environment if you store it with the power cable disconnected.Storage temperature: -20°C to 60°C (with no freezing)Storage humidity: 20% to 80% relative humidity (with no condensation) | |||||||
Shock Resistance*2 | Impact Acceleration Rate at Flange | 490 m/s2 | ||||||
Number of Impacts | 2 times | |||||||
VibrationResistance*3 | Vibration Acceleration Rate at Flange | 49 m/s2 | ||||||
Applicable SERVO- PACKs | SGD7S- | R70A, R70F | R90A, R90F | 1R6A, 2R1F | 2R8A,2R8F | 5R5A | ||
SGD7W- SGD7C- | 1R6A*6, 2R8A*6 | 1R6A, 2R8A*6 | 2R8A,5R5A*6,7R6A*6 | 5R5A, 7R6A |
*1. A vibration class of V15 indicates a vibration amplitude of 15 mm maximum on the Servomotor without a load at the rated motor speed.Shock Applied to the Servomotor*2. The shock resistance for shock in the vertical direction when the Servomotor is mounted with the shaft in a hor- izontal position is given in the above table.
*3. The vertical, side-to-side, and front-to-back vibration resistance for vibration in three directions when the Servo- motor is mounted with the shaft in a horizontal position is given in the above table. The strength of the vibration that the Servomotor can withstand depends on the application. Always check the vibration acceleration rate that is applied to the Servomotor with the actual equipment. other performances may be lower than those achieved with a S-7S SERVOPACK.